The Reasons You Need Utility Locators, Concrete X-ray Scanners or Concrete Radars It is not the right choice to destroy the concrete the moment you realize that it has a problem that you want to attend to. The reason is that there are other ways you can identify the problem without interfering with it. You can instead use the concrete radar or the X-ray scanner. Depending on your needs both of them have their advantages. The X-ray scanner can, for example, be used in finding the available cables or rebar on the ground. The WHO has classified the X rays as carcinogen and therefore when you use this technique you should evacuate everyone in the area. The people doing the job should also wear protective gears. The other more efficient process which is quicker and safer to use in the ground penetrating radar. Everything that is in the concrete will be readily detected by the concrete radar. Structures like the towers and bridges can employ this process of using the radar only if the concrete is not exceeding 18 inches in thickness. Any anomaly that is identified in the concrete or the surface will be easily mapped by the GPR image.
Why not learn more about Utilities?
On the advantages, you will find that despite the health threats it poses, the X-ray is better than the GPR. Using the X-ray enables a person to identify even the smallest items or fractures in the wall. It is easy to use the computer in the different aspects of a scanner such as a tomography and a fluoroscopy. This is among where you sometimes want to use the X-ray over the ground penetrating radar.
The Best Advice on Maps I’ve found
The two technologies also can be compared by looking at the amount of money incurred when you hire either of them. The X-ray scanner is usually more expensive than the concrete radar. The GPR has also been lately improved and the software that is being used can be manipulated, and easy processing of image is enabled. Combining with that it is cheaper than the scanner, many people are going to the radar system. It is convenient in many areas except those that are wet because they are less effective. When you have a job that requires some bit of cutting or drilling or even coring, using an X-ray scanner will be beneficial over using the GPR. The entire project will have a better and a clear image that when the radar would have been used. You will see your project in all the angles if some bit of utility location and leak detection are incorporated. It is prudent to go for the company that will have the latest equipment for such a project. A lot of professionalism is needed in this field.